BCI 1884SS Instrucciones de operaciones descargar pdf (Pagina 30)

Chapter 7: Printer

7-4 Pulse Oximeter for Sleep Screening Operation Manual

Trend Printouts

Collecting Trend Data

Whenever the monitor is on, it stores one SpO

and one pulse rate reading every 4 seconds.

The stored readings are called trend data. The monitor remembers trend data for up to 12

hours of run-time, depending upon battery life.

Trend data will be preserved for about one and a half minutes, without battery power, allowing

battery replacement without losing trend data.

Trend memory will contain data for only one patient.

Trends will be cleared by pressing and holding the

F key for 6 to 8 seconds, at power-up. A

“clr” message will flash to indicate that trend clear is about to happen.

New data will not overwrite old data when the end of memory is reached.

NOTE! Turning the monitor OFF and back ON during Trend Collection will “freeze” trend

information and place the monitor in the Trend Printing Mode. The monitor must have

the trend data cleared and reset to begin Trend Collection again.

Paper Feed

To advance paper through the printer, press and hold

F for 3 seconds (not at power up). The

paper-feed will start. Press the

F key again to stop the printer, otherwise the printer will stop

in about 25 seconds after printing 30 empty lines. This is enough time to flip the device over

and slide the paper end into the slot until the printer captures the paper and feeds it through. If

the user feeds the paper in a shorter period of time, the printer can be stopped by pressing the

F key again.

Fig 7.2 Paper Advance

1. Paper exit.

CAUTION! When printing, or advancing the paper, place the oximeter on it’s side to

prevent paper jams. Also, cutting the paper as shown below will facilitate feeding paper

into the printer.

Fig 7.3 Paper Shape



1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 42 43

Sin comentarios

BCI 1884SS Instrucciones de operaciones Pagina 30