BCI 1884SS Instrucciones de operaciones descargar pdf (Pagina 35)

Chapter 10: Troubleshooting

Pulse Oximeter for Sleep Screening Operation Manual 10-1

Chapter 10: Troubleshooting

Problem Possible Cause Corrective Action

No pulse shown on the

bargraph.

Patient cable or sensor

is disconnected from the

oximeter.

Sensor is incorrectly

positioned on the

patient.

Poor patient perfusion.

Defective sensor or

patient cable.

Monitor is in the Data

Collection or Trend Print

Mode.

Check sensor connections to the

patient cable and to the oximeter.

Reposition the sensor.

Reposition the sensor.

Try a new sensor or contact your

authorized repair center for help.

None required.

Pulse rate is erratic,

intermittent, or incorrect.

Sensor incorrectly

positioned.

Patient motion

Reposition the sensor.

Patient must remain still to obtain an

accurate measurement.

SpO

2

value is erratic,

intermittent, or incorrect.

Poor patient perfusion.

Patient motion.

Reposition the sensor

Patient must remain still to obtain an

accurate measurement.

The oximeter doesn't

turn on.

Batteries weak.

Batteries not installed or

batteries incorrectly

installed.

Replace the batteries.

Ensure the batteries are installed

correctly.

The oximeter displays

only one flashing LED

with no SpO

2

or heart

rate

The oximeter has been

on continuously and

collecting data for 10

minutes and has gone

into the Data Collection

Mode.

If not collecting trend data, press and

hold the

x

key for 6 seconds, which

will turn off the unit. To return monitor

to Verification Mode, hold

F key for 6

to 8 seconds at power up. This will

clear the trend data and switch the

unit to the Verification Mode.

No printout on built-in

printer.

Batteries are weak.

Batteries are not

properly installed.

No trends in memory.

Printer interface

malfunction.

Replace the batteries.

Ensure the batteries are installed

properly.

Take trend data.

Contact your authorized repair center

for help.

E00 ROM Error Contact service representative

E01 RAM Error Contact service representative

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42 43

Comentarios a estos manuales

Sin comentarios